Now that I got my design it is time to built the cabinet itself. I am not a good woodworker, I just document my journey here so please keep that in mind. If you're serious about building an arcade cabinet I'd suggest you read and watch many tutorial like this, everyone does it a little bit different.

I bought a few sheets of MDF at 18mm and 8mm thicknesses

Gathering wood

I started off with a single side panel, I did not have a proper workbench so I had the sheet of MDF on the ground. First I marked the outline of the side panel.

Sidepanel outline

I had some trouble with getting the angles right so I 3D printed a few pieces to help me with that.

3D printed helper 3D printed helper

Then is was time to cut the sidepanels!

Cutting sidepanels Sidepanel

After cutting the two side I used a router to get them equal.

Router equal

I used my design to measure and cut a lot of the panels

Panels

Next I added wooden blocks to the side panel for where the connecting plates should mount

Blocks

Then I started assembling the cabinet

Connecting Connecting Connecting Connecting

I wanted to be able to easily access the underside of the control panel so I decided to use hinges like these:

Hinge

But as you can see there is quite a bit of space so I routed out a little part for the hinge

Hinge routed

To be able to move the cabinet easily I mounted two wheels on the underside

Wheels

At this point all the panels were mounted and most holes were cut so it was time for painting. I did two layers of primer and two layers of black matte paint.

Primer Black paint

After painting it was time to bring the cabinet inside!

Inside

Finally I applied a dark wood vinyl and black T-molding:

Vinyl T-Molding

That's it for this part, in the next part we will start with the electronics.